Olympus OmniScan SX - Help Key; Indicator Lights; Power Indicator Light; Power Key

DMTA-20043-01EN [U8778624], Rev. B, May 2013
Overview of the OmniScan SX 23
2.3 Power Key
The Power key (see Figure 2-1 on page 21) is used to start or shut down the
OmniScan SX, but also to enable or disable the sleep mode.
2.4 Help Key
The Help key (see Figure 2-1 on page 21) is located on the upper-right side of the
OmniScan SX front panel. Pressing this key displays the online help for the currently
selected function.
2.5 Indicator Lights
There are three types of indicator lights on the OmniScan SX front panel: power,
acquisition, and alarm. Each indicator light is described below.
2.5.1 Power Indicator Light
The power indicator light is located above the Power key. The color of this light
identifies the power status of the OmniScan SX (see Table 3 on page 23).
Table 3 Power indicator light statuses
Off The OmniScan SX is turned off.
Flashing orange The OmniScan SX is turned off. Battery is charging.
Orange The OmniScan SX is turned off. Battery charging is
complete.
Green • The OmniScan SX is turned on.
• The OmniScan SX is turned on and battery is charging.
Flashing
green/orange
The OmniScan SX is in sleep mode. The battery is
charging.