Olympus OmniScan SX - Sleep Mode; Figure 3-1 the Shut down Button; Figure 3-2 Saving the Setup

DMTA-20043-01EN [U8778624], Rev. B, May 2013
34 Chapter 3
Figure 3-1 The Shut Down button
2. Select Shut Down (see Figure 3-3 on page 35).
A message asking you if you want to save your setup appears (see Figure 3-2 on
page 34).
Figure 3-2 Saving the setup
3. To save your setup, select Yes.
You can also turn off the OmniScan SX by pressing and holding the Power key for ten
seconds. However, your setup will NOT be saved.
3.2 Sleep Mode
The OmniScan SX can be put into sleep mode when not in use to conserve power.
To use the sleep mode
1. With the OmniScan SX turned on, quickly press the Power key.
The Shut Down button