DMTA-20043-01EN [U8778624], Rev. B, May 2013
28 Chapter 2
P1 (UT connector)
LEMO connector used for the transmission of ultrasonic signals when using the
pitch-catch inspection technique.
R1 (UT connector)
LEMO connector used for the reception of ultrasonic signals when using the
pitch-catch inspection technique.
Scanner interface
Used as an alarm output and control input.
PA connector
Used to connect a phased array probe.
The compatible probe connectors are presented in Figure 2-5 on page 28.
Figure 2-5 LEMO and phased array probe connectors
2.9 Rear Panel
The rear panel consists of the heat sink and the support stand (see Figure 2-6 on
page 29).
Phased array probe connector
LEMO connector
To Next Page
Loading...
