Olympus USPM-RUIII Series - Page 20

PV6088-F4E017
20
3.4.Names of the parts of the control box (UCB-01)
3.5. Features of the control box (UCB-01)
(1) Power switch
Turns the control box power on/off.
(2) USB connector
Terminal to send and receive the control signals. Connected with the computer via
the USB cable.
(3) Main unit connector
Terminal to supply power for sending/receiving control signals and the controller
functions. Connected with the main unit via the main unit cable (DC 12V
output ).
(4) Photometric connector
Terminal to supply power for sending/receiving control signals and the controller
functions. Connected with the photometric head via the photometric cable (DC 12V
output ).
(5) Power inlet
Supplies AC power to the control box via the power cord. This inlet also contains a
fuse. For details on replacing fuses, refer to 7. REPLACEMENT OF FUSES.
(6) IO connector
Terminal to receive and send the control signals. Connected with the light source
power supply via the IO cable.
Figure 2. Control box
(1) Power switch
(2) USB connector
(5) Power inlet
(6) IO connector
(3) Main unit connector
(4) Photometric connector