Olympus WS-813 - Setting Recorder Time and Date

22
1
EN
Setting the time and date
Setting the time and date [Time & Date]
Changing the time and date
5 Press the ` OK button.
• [ Time & Date ] appears on the display.
• “ H o u r ” flashes on the display,
indicating the start of the Time and
Date setup process.
3 Press the ` OK button to move
the cursor to the item you want
to set.
• [ Device Menu ] appears on the
display.
4 Press the + or − button to select
[
Time & Date ].
1 While the recorder is in stop
mode, press the MENU button.
• The menu will appear on the display
( ☞ P.53).
2 Press the + or − button to select
[ Device Menu ] tab.
• You can change the menu display by
moving the settings tab cursor.
While the recorder is in stop mode,
press and hold the STOP ( 4 ) button to
display [ Time & date ] and [ R e m a i n ] .
If the current time and date are not
correct, set them using the procedure
below.
The following steps are the same as
Step 1 through Step 3 of “ Setting the
time and date [ Time & Date ] ” ( ☞ P.21).
6 Press the STOP ( 4 ) button to
close the menu screen.
+ − button
9 0 button
`
OK button
STOP ( 4 ) button
MENU button