6-2Pagina 6-2 di 57
MFOX04500910 FOX 45
6.2 Safety standards for maintenance
Before starting the maintenance and inspection procedures, always perform the following operations:
pick-up the technical documentation for the system;
check that the documentation and system match ;
Always wear adequate clothing and accident-prevention equipment during the various phases of
maintenance. In particular:
- Overalls with snug-fitting cuffs
- Goggles/safety glasses
- Gloves
- Helmet
- Dust mask
- Safety Harness
- Safety shoes
Always use equipment that is in good condition
have on hand a portable lamp to light the areas under maintenance.
identify system cut-off switches;
Cut off power to the electrical system before performing any operation near or on moving mechanical
parts or before performing any operation on powered parts of the system.
Lock the cut-off switch in the open position using a padlock
make certain that the system is not repowered while the works are in progress
NEVER operate directly on control breaker
NEVER lubricate parts while they are moving
To Next Page
Loading...
