OMNI 4000/7000 Operations and Maintenance Guide – Rev F
If a Station is running a Common Batch Stack, it will be listed on its Batch Control
screen (left). The Meter Runs assigned to this stack will display a notice (right) rather
than any batch details (as it would for an Independent Batch).
If a stack is not configured in OMNICONNECT, the flow computer will display
a notice.
a. Continue to view or edit batch stacks,
as needed.
b. When finished, press the Back key to
return to the Batch Operations
screen or the Home key to return to
the Home screen.
Recalculate Previous Batches
Previous batches may need to be recalculated based on updated volume correction data, such as
%BS&W or reference gravity/density, which is usually determined by laboratory analysis.
To access previous batch records and recalculate them, follow these instructions:
a. From the Batch Operation screen,
select Recalc Prev Batch.
b. Press OK.
To Next Page
Loading...
Need help?
General
