OMNI 4000/7000 Operations and Maintenance Guide – Rev F
3.5.2 Prove Configuration
To access proving configuration settings, follow these instructions:
In the Actions ribbon, click Configure.
a. Expand the Prover function in the
Configure tree.
b. Select Configuration and Setup to
display the Prover configuration
options in the screens on the right.
a. Select the Prover Type as discussed
in Prove Types in Section 3.5.1.
b. Click Apply.
a. Select the Prover Characteristics tab
(liquid applications only), and verify or
make changes to the settings.
b. Click Apply.