Omni 7000 Series User Manual

OMNI 4000/7000 Operations and Maintenance Guide – Rev F
7-37
Maintenance
2.
a. On the Utilities screen, use the arrow
keys to navigate to the Calibration
menu selection.
b. Press OK.
3.
a. Use the arrow keys to scroll down and
highlight Maintenance Mode.
b. Press OK.
4.
Maintenance Mode is disabled by default.
Use the right and left arrow keys to
navigate to different Meter Runs, if
needed.
When ready to enable Maintenance Mode,
press the FR/Totals function key.
5.
The Maint Mode Flow/Totals screen
displays a list of all the flow rates and
totalizers you can adjust in this mode.
Press the Set Res function key to enter
new decimal resolutions.
6.
Use the Up and Down arrow navigation
keys to scroll to and highlight the flow or
totalizer decimal resolution you wish to
change and press OK to open the entry
field.
7.
Enter the new value for your selection and
press OK.

Omni 7000 Series Specifications

General

Brand	Omni
Model	7000 Series
Category	Desktop
Language	English