Omni 7000 Series User Manual

OMNI 4000/7000 Operations and Maintenance Guide – Rev F
3-15
OMNICONNECT® Operations
Assign Gas Product to Meter Run
In liquid applications, products are assigned to Meter Runs using batches and batch stacks. Go to
Section 3.6
Batch Operations for more information on batches.
To assign a gas fluid product to a Meter Run, follow these instructions:
1.
In the Actions ribbon, click Configure.
2.
a. Expand a Meter Run in the
Configure tree.
b. Click on Flowmeter to display its
configuration options in the screens
on the right.
3.
In the lower right-hand corner of the Setup
screen, select a product number in the
Flow Stream group to assign that product
stream to that Meter Run.
4.
When you are finished with the Setup
screen, click Apply to save your changes.
5.
Continue to assign products to other Meter
Runs, as needed.
This number corresponds to the
numbered gas fluid product
(1 through 6) listed under Fluid
Products in the Configure tree.

Omni 7000 Series Specifications

General

Brand	Omni
Model	7000 Series
Category	Desktop
Language	English