Omron fh series User Manual

Software keyboard
The following software keyboard is displayed in the window for inputting text depending on the sensor
controller.
Switching operation will differ depending on the software keyboard.
l
FH/FHV Series
Tilde key
Application key
Switch between Japanese (hiragana) input/Japanese (katakana) input/Alphabet-Japanese convert-
ed input using the following procedure.
• Use the Keyboard Layout Selection Tool to switch between keyboard display languages. Refer
to 10-5 Setting the Keyboard Layout for the Controller [Keyboard Layout Selection Tool] on page
10 - 46.
• Use the following procedure to switch between kana input and alphabet-Japanese converted in-
put.
The software keyboard uses an English keyboard layout, with alphabet-Japanese converted in-
put the default. Switching the keyboard display language to Japanese switches to kana input.
(1) To switch between Japanese (katakana) input/Alphabet-Japanese converted input, click Ctrl
+ Shift + Caps.
To use the Ctrl + Shift + Caps key combination, first hold down Ctrl, then hold down Shift
and press Caps.
Then, release Caps, release Shift, then release Ctrl.
(2) Display the keys and carry out text input, and confirm the keyboard has been switched.
• Use the following procedure to switch kana-kanji conversion ON/OFF.
To input kanji characters, it is necessary to start the IME. There are two ways to do this.
(1) To toggle between IME ON/OFF, press Alt + ~ (tilde).
To use the Alt + ~ key combination, first hold down Alt, and while doing so, press and press
again ~.
(2) Alternatively, turn the IME ON by pressing the Application key, and from the menu, select
Open IME.
To turn the IME OFF, press the Application key, and from the menu, select Close IME.
Additional Information
• If you connect a keyboard to the Sensor Controller with a USB connection, the key arrange-
ment will be the same as an English keyboard.
• In Japanese, the [¥] (yen) character is used to indicate paths between folders, however if the
¥ character is not shown on the keyboard, then substitute the [\] (backslash) key.
3 Basic Operations
3 - 7
FH/FHV Series Vision System User’s Manual (Z365-E1)
3-2 Basic Knowledge about Operations
3
3-2-2 Inputting Text

Omron fh series Specifications

General

Type	Machine Vision System
Series	FH Series
Power Supply	24 VDC
Storage Temperature	-20 to 60°C
Humidity	35 to 85% RH (non-condensing)
Image Sensor	CMOS
Processing Speed	High-speed processing
Connectivity	Ethernet
I/O	Digital I/O
Operating System	Embedded OS
I/O Ports	Ethernet, USB