Omron FHV Series

To Next Page

To Previous Page

Section 5 Installation

5-1 Assembling Equipment .......................................................................................................5 - 2

5-1-1 C Mount Lens / IP40 Configuration ...........................................................................................5 - 2

5-1-2 C Mount Lens / IP67 Configuration ...........................................................................................5 - 3

5-1-3 Lens Module / IP40 Configuration.............................................................................................5 - 5

5-1-4 Lens Module / IP67 Configuration.............................................................................................5 - 8

5-1-5 Lens Module / Internal Lighting / IP67 Configuration ..............................................................5 - 10

5-2 Installing the Smart Camera .............................................................................................5 - 14

5-2-1 How to Connect.......................................................................................................................5 - 14

5-2-2 When Connecting the Smart Camera to a Lighting Controller ................................................5 - 18

Section 6 Power Supply and I/O Interface

6-1 When Turning Power ON and OFF .....................................................................................6 - 2

6-2 Fail-safe Measures...............................................................................................................6 - 4

6-3 Precautions for I/O Interface...............................................................................................6 - 5

6-4 I/O Cable Interface (Power Supply, I/O, RS-232C).............................................................6 - 6

6-4-1 Recommended Power Supply for FHV Series ..........................................................................6 - 6

6-4-2 Cables .......................................................................................................................................6 - 7

6-4-3 Pin Layout .................................................................................................................................6 - 8

6-4-4 Interface Specifications .............................................................................................................6 - 9

6-4-5 I/O Interface Input / Output Circuit Diagram............................................................................6 - 12

6-4-6 RS-232C Interface ..................................................................................................................6 - 14

6-5 Ethernet Interface ..............................................................................................................6 - 15

6-5-1 Cables .....................................................................................................................................6 - 16

6-5-2 Pin Layout ...............................................................................................................................6 - 17

6-6 Inserting and Removing the MicroSD Card.....................................................................6 - 18

6-6-1 How to Insert / Remove the MicroSD Card .............................................................................6 - 18

Section 7 Software Setup

7-1 Setting up the Software.......................................................................................................7 - 2

7-1-1 Recommended Operational Environment .................................................................................7 - 2

7-1-2 Installation .................................................................................................................................7 - 2

7-1-3 Windows....................................................................................................................................7 - 3

7-1-4 Use Procedures ........................................................................................................................7 - 4

7-2 Operating the Smart Camera Remotely [Remote Operation Tool] ................................7 - 10

7-2-1 Summary.................................................................................................................................7 - 10

7-2-2 Environment Settings ..............................................................................................................7 - 11

7-2-3 Network Settings for the Remote Operation PC .....................................................................7 - 11

7-2-4 Network Settings for the Smart Camera .................................................................................7 - 12

7-2-5 Network Settings for the Smart Camera with Remote Operation Tool ....................................7 - 14

7-2-6 Launching the Remote Operation ...........................................................................................7 - 14

7-2-7 Terminating the Remote Operation .........................................................................................7 - 17

7-3 Using the Simulation Software [Simulation Software] ...................................................7 - 18

7-3-1 Introduction .............................................................................................................................7 - 18

7-3-2 Available Image Formats.........................................................................................................7 - 18

7-3-3 Operational Precautions..........................................................................................................7 - 18

Index

CONTENTS

FHV Series Smart Camera Setup Manual (Z408-E1)