Omron NX-ID - Page 363

To Next Page

To Previous Page

A - 113

Appendices

NX-series Digital I/O Unit User’s Manual (W521)

A-3 Connecting Connector-Terminal Block

Conversion Units and I/O Relay Terminals

A-3-3 Connector-Terminal Block Conversion Unit Connection Diagrams

Note 1. The polarity for input power supply connections

indicated with dotted lines (

) can be con-

nected in either direction provided that the same

polarity is used for the commons.

2. Both COM0 and COM1 have two pins each. They

are internally connected inside the Unit, but they

must all be wired.

Note 1. The polarity for input power supply connections

indicated with dotted lines (

) can be con-

nected in either direction provided that the same

polarity is used for the commons.

2. Both COM0 and COM1 have two pins each. They

are internally connected inside the Unit, but they

must all be wired.

Digital I/O

Unit

NX-ID6142-6

Connec-

tor-Terminal

Block Con-

version Unit

XW2D-40G6

XW2D-40G6-RF

Connecting

Cable

XW2Z-

B

Connection

diagram

Wd m Wd (m+1)

A20

A11

A12

A13

A14

A15

A16

A17

A18

A19

B20

B11

B12

B13

B14

B15

B16

B17

B18

B19

A10

B10

COM0

COM1

24 VDC