Omron STC-MCS500POE

No.18S111-03
48/70
STC-MBS500POE / STC-MCS500POE
Product Specifications and User’s Guide
10.10 Pixel Format
The image format from camera can be set on Pixel Format.
GenICam Parameters
PixelFormat IEnumeration Type Pixel Format
The following chart shows the available Pixel Formats on camera:
Output Bits Pixel Format
Monochrome Camera
STC-MBS500POE
Color Camera
STC-MCS500POE
8bits Mono8 Mono8 BayerRG8
10bits Mono10 Mono10 BayerRG10
10bits Packed Mono10Packed Mono10Packed BayerRG10Packed
12bits Mono12 Mono12 BayerRG12
12bits Packed Mono12Packed Mono12Packed BayerRG12Packed
8bits x 3 N/A RGB8
Each format specified on GenICam PFNC (Pixel Format Naming Convention).
10.11 Decimation
When using Decimation mode, the decimated image can be output.
The images below show decimated pixels (red squares) where they are output.
＜STC-MBS500POE＞ ＜STC-MCS500POE＞
Decimation X (OFF), Y (OFF) Decimation X (ON), Y (ON)Decimation X (OFF), Y (OFF) Decimation X (ON), Y (ON)
GenICam Parameter
DecimationHorizontal IInteger Type Sets decimation on horizontal direction
Selection: 1: Disable Decimation, 2: Decimate one of two pixels
Default: Disable Decimation
DecimationVertical IInteger Type Sets decimation on vertical direction
Selection: 1: Disable Decimation, 2: Decimate one of two pixels
Default: Disable Decimation
(*1) Decimation cannot change horizontal only or vertical only. Selection applies for horizontal and vertical.
(*2) It is necessary to change exposure time (to shorten exposure time), to increase frame rate when using
Decimation.