48
En
You can reset a REMOTE MODE to its default remote
control code.
You can reset the remote controller to its default settings.
By pressing REMOTE MODE that’s been programmed
with the remote control code for your component, you can
control Onkyo component as below.
For details on entering a remote control code for a
different component (➔ page 47).
Controlling a Blu-ray Disc/DVD Player, HD
DVD Player
BD/DVD is preprogrammed with the remote control code
for controlling a component that supports the p
*1
.
The component must be able to receive remote control
commands via p and be connected to the AV
receiver via HDMI.
Use the following remote control codes:
` 32910/33001/31612:
Blu-ray Disc/DVD player with p
*1
The p supported by the AV receiver is the CEC
system control function of the HDMI standard.
Resetting REMOTE MODE Buttons
1
While holding down REMOTE MODE that you
want to reset, press and hold down HOME until the
remote indicator lights (about 3 seconds).
2
Within 30 seconds, press REMOTE MODE again.
The remote indicator flashes twice, indicating that the
button has been reset.
Each of REMOTE MODE is preprogrammed with a
remote control code. When a button is reset, its
preprogrammed code is restored.
Resetting the Remote Controller
1
While holding down RECEIVER, press and hold
down HOME until the remote indicator lights
(about 3 seconds).
2
Within 30 seconds, press RECEIVER again.
The remote indicator flashes twice, indicating that the
remote controller has been reset.
Controlling Other Components
To Next Page
Loading...
Need help?
General
Weight and Dimensions
