28
En
When the Direct function is off, the tone controls can be
used to adjust the sound. When the Direct function is on,
the tone controls are bypassed, so you can enjoy a pure
sound, then front display goes off and the Direct LED
lights.
Note
• The display lights for 5 seconds if you control anything else than
volume or DIMMER on the front panel or remote controller
when the display brightness is set to OFF.
You can adjust the brightness of the preamplifier’s display.
Note
• The display lights for 5 seconds if you control anything else than
volume on the front panel or remote controller when the display
brightness is set to OFF.
You can display the selected selector or the setting value.
Note
• Input fs (sampling rate) and output fs (sampling rate) are
displayed only while the DIGITAL selector is selected.
• Depending on the source, sometimes the value of the sampling
rate differs from the actual display.
Using the Direct Function
1
Press DIRECT on the preamplifier to turn the
Direct function on or off.
DIRECT
Direct LED
Adjusting the Display Brightness
1
Press DIMMER repeatedly to change the brightness
of the display in sequence.
Normal→Dim → Off
Display Off LED
DIMMER
Normal
Dim
Off
The Display Off LED lights.
Changing the Display information
1
Press DISPLAY to switch the display in sequence.
DISPLAY
Selector
BASS
TREBLE
Input fs (sampling rate)
fs indicator
Output fs (sampling rate)