Onkyo P-3000R User Manual

35
En
When ASb is turned on, the preamplifier will
automatically enter Standby mode if there is no operation
for 30 minutes with no audio signal input.
You can also use preamplifier’s MODE and Multi jog dial.
See “Using MODE button” to perform this procedure on
the preamplifier (➔ 29).
Once the ASb function has been activated, the
preamplifier will not automatically turn on even if it
receives the signal. To turn on the preamplifier, press
ON/STANDBY manually.
Note
• When the set ASb starts running, the power of the Onkyo Dock
connected via RI is automatically turned off (➔ 32).
• The preamplifier will cancel the setup if there is no operation for
8 seconds.
• Before entering standby mode with the ASb function, the
Display Off LED flashes 30 seconds before the ASb function
starts running.
Switch L2 OUT to enable the volume adjustment from
another component connected to the preamplifier.
You can also use preamplifier’s MODE and Multi jog dial.
See “Using MODE button” to perform this procedure on
the preamplifier (➔ 29).
Note
• The preamplifier will cancel the setup if there is no operation for
8 seconds.
• To check the connection in which this setting is enabled, see
“Using Stereo Speakers as the Front Speakers for Your Surround
Sound System” (➔ 23).
• When plugging other components such as compact disc players
into the LINE 2 jack, change the “L2 OUT” setting to
“NORMAL”.
Setting ASb (Auto Standby)
1
Press SETUP.
2
Press #/$ to select “ASb”.
3
Press ENTER.
4
Press #/$ to switch between “ASb ON” and
“ASb OFF”.
` ASb ON:
ASb enabled.
` ASb OFF:
ASb disabled.
Default setting: ASb ON (European models),
ASb OFF (North American models)
Display Off LED
SETUP
#, $
ENTER
5
Press ENTER.
“FINISH” appears on the display.
LINE 2 Output with a Fixed Volume
1
Press SETUP.
2
Press #/$ to select “L2 OUT”.
3
Press ENTER.
SETUP
#, $
ENTER
4
Press #/$ to switch between “NORMAL” and
“THROUGH”.
` NORMAL:
You can adjust the PRE OUT volume by the
preamplifier’s volume controller when the signal
coming from the LINE 2 IN is output from the
PRE OUT.
` THROUGH:
The PRE OUT output of the preamplifier is
fixed.
5
Press ENTER.
“FINISH” appears on the display.

Onkyo P-3000R Specifications

General

Output level	0.001 mV
Amplifier class	-
Frequency range	5 - 100000 Hz
Output impedance	330 Ω
Input sensitivity	200 mV
Audio output channels	- channels
Peak power per channel	- W
Signal-to-Noise Ratio (SNR)	110 dB
Total Harmonic Distortion (THD)	0.005 %
AC (power) in	Yes
Audio (L/R) in	5
USB 2.0 ports quantity	1
Digital audio optical in	2
Speakers connectivity type	RCA
Purpose	Home
Product color	Silver
Volume control	Rotary
Cables included	AC
Connectivity technology	Wired
AC input voltage	230 V
AC input frequency	50 Hz
Power consumption (typical)	29 W
Package weight	12500 g

Weight and Dimensions

Depth	333.1 mm
Width	435 mm
Height	99 mm
Weight	11000 g