33
En
Advanced Oper ations
Custom Setup
You can switch the selector name to DC/DIG to run as the
DOCK selector.
■ To cancel the assignment
Press DISPLAY again for 3 seconds.
Note
• DOCK can be selected for the Digital input source (COAX1,
COAX2, OPT1, OPT2) input selector, but not at the same time.
You can convert the sampling rate of the input digital
signal.
Note
• If the sampling rate is greater than 192/176.4 kHz, the sampling
rate conversion will not be applied.
• Only analog audio is output by converting sampling rates. No
digital audio is reproduced.
• To confirm the current setting value, see “Changing the Display
information” (➔ 28).
• Digital input signals are put through and output on this
preamplifier as is.
•The USB input does not support FS x4 (➔ 31).
Offset the volume level based on master volume.
You can also use preamplifier’s MODE and Multi jog dial.
See “Using MODE button” to perform this procedure on
the preamplifier (➔ 29).
Note
• The preamplifier will end the setup if there is no operation for
8 seconds.
Changing the Selector Name
1
Select the Digital input source (COAX1, COAX2,
OPT1, OPT2) to change the selector name.
2
Press DISPLAY for 3 seconds.
“DC/DIG” is displayed on the display.
DISPLAY
Selecting the Sampling Rate
Conversion
1
Press SRC repeatedly on the preamplifier.
` BYPASS (default):
Outputs the input sampling rate at the original
sampling rate.
` FS x2:
Outputs the input sampling rate by converting it
to x2.
` FS x4:
Outputs the input sampling rate by converting it
to x4.
SRC
Setting the Bi-amp Level
1
Press SETUP.
2
Press #/$ to select “BIAMP”.
3
Press ENTER.
4
Press #/$ to adjust the bi-amp level.
The high and low output balance can be adjusted.
The setting has been established.
SETUP
#, $
ENTER
To Next Page
Loading...
Need help?
General
Weight and Dimensions
