Onkyo P-3000R

34
En
You can set the volume when using headphones.
You can also use preamplifier’s MODE and Multi jog dial.
See “Using MODE button” to perform this procedure on
the preamplifier (➔ 29).
Note
• When using the headphones, the balance setting will not be
applied.
• The preamplifier will end the setup if there is no operation for
8 seconds.
Setting the Headphone Level
1
Press SETUP.
2
Press #/$ to select “HPLEVEL”.
3
Press ENTER.
4
Press #/$ to adjust the volume level.
The setting has been established.
SETUP
#, $
ENTER
The TAPE OUT (LINE OUT) jack can produce audio
output by connecting the cassette tape deck with the
preamplifier.
You can also use preamplifier’s MODE and Multi jog dial.
See “Using MODE button” to perform this procedure on
the preamplifier (➔ 29).
Tip
Usage example of RECOUT:
• Perform recording by connecting the turntable to P-3000R
(PHONO IN jack), and the cassette tape deck to LINE 3
(IN/OUT jack) of P-3000R.
Note
• The preamplifier will cancel the setup if there is no operation for
8 seconds.
• When connecting a component such as a cassette tape deck,
change the “LINEOUT” setting to “RECOUT” for anti-
vibration purpose.
Selecting the Analog Audio Out
1
Press SETUP.
2
Press #/$ to select “LINEOUT”.
3
Press ENTER.
4
Press #/$ to switch between “LINEOUT” and
“RECOUT”.
` LINEOUT (LINE 3)
Outputs any signal from the input selector.
` RECOUT (TAPE)
The selector name becomes TAPE. Signals input from
LINE 3 IN will not be output from LINE OUT.
5
Press ENTER.
“FINISH” appears on the display.
SETUP
#, $
ENTER