OnRobot RG6 - Introduction; Important Safety Notice; Scope of the Manual; Naming Convention

Introduction
4
1 Introduction
1.1 Important Safety Notice
DANGER:
You must read, understand, and follow all safety information in this
manual, and the robot manual and all associated equipment before
initiating robot motion. Failure to comply with safety information could
result in death or serious injury.
1.2 Scope of the Manual
The manual covers the following OnRobot products and its components:
Grippers
Version
Gecko Gripper
v2
RG2
v2
RG2-FT
v2
RG6
v2
VG10
v2
VGC10
v1
Sensors
Version
HEX-E QC
v3
HEX-H QC
v3
Where applicable the combination of the products is also covered in the manual.
NOTE:
Generally, the products without the Quick Changer v2 interface, are not
in the scope of this manual.
1.3 Naming convention
In the user manual Gecko Gripper is called Gecko only.
The RG2 and RG6 names as model variants are used separately or together as RG2/6 if the information is
relevant for both variants.
The HEX-E QC and HEX-H QC names as model variants are used separately or together as HEX-E/H QC if
the information is relevant for both variants.