Openpath Core Series - Page 2





Openpath Access Control System Installation Guide 
GETTING STARTED 
ADDITIONAL RESOURCES 
PRIOR TO INSTALLATION 
Installation 
NETWORK REQUIREMENTS 
SELECTING A BACKUP BATTERY 
MOUNTING INSTRUCTIONS 
INSTALLING CORE SERIES BOARDS IN E1 ENCLOSURE 
INSTALLING CORE SERIES BOARDS IN E2 ENCLOSURE 
INSTALLING CONTROLLER BOARD WITH 24V LOCKING HARDWARE 
INSTALLING CONTROLLER BOARD WITH 12V LOCKING HARDWARE 
WIRING OPENPATH READERS 
STANDARD CONFIGURATIONS 
WIRING THE CORE SERIES 24V 4-DOOR SMART HUB 
WIRING THE CORE SERIES 12/24V 4-DOOR SMART HUB 
WIRING THE CORE SERIES 24V ELEVATOR SMART HUB 
ELEVATOR BUTTON WIRING 
GENERAL PURPOSE INPUTS 
WIRING THE CORE SERIES 12/24V 8-DOOR SMART HUB 
WIRING WITH THE 12/24V POWER SUPPLY 
WIRING THE REX WITH THE DOOR STRIKE 
WIRING THE REX WITH THE ELECTROMAGNETIC LOCK 
WIRING FAIL SAFE AND FAIL SECURE LOCKING HARDWARE 
WIRING THE OPENPATH ELEVATOR BOARD TO A STANDALONE CONTROLLER BOARD 
ADVANCED CONFIGURATIONS 
CHANGING I/O TYPES 
WIRING TO LEGACY PANELS AND MOBILE GATEWAY 
WIRING TO WIEGAND DEVICES ON CORE SERIES SMART HUBS 
END-OF-LINE SUPERVISION 
Troubleshooting 
ACU LEDS 
CORE STATUS LED 
READER LEDS 
LEGACY WIRING 
RESETTING THE ACU 
SOFT RESET 
HARD RESET 
PROVISIONING THE ACU 
REQUIREMENTS 
CREATE ACU IN CONTROL CENTER 
PROVISIONING STEPS 
NETWORK SETTINGS 
Regulatory 
UL 294 
CAN/ULC 60839-11-1-16 GRADE 1 
FCC 
IEC 62368-1 
RF Radiation Hazard Warning 
Industry Canada Notice and Marking 
Warnings 
Technical Specifications 

Version 1.8 
© Openpath 2020 
Page 2 
