The protective frame unit is supplied with the insert, but disassembled from the same, therefore the insert must be assembled
in the installation phase, after the frame has been pre-assembled (see Figure 2).
Figure 2 Parts that make up the protective frame - mod. Q9 DUCTED
PARTS LIST
ELEMENT DESCRIPTION
1 Upper protection
2 Side protection
3 Self-threading screw
4 Boiler/protection anchorage bracket
Assembly of the protection frame on insert
PARTS LIST
ELEMENT DESCRIPTION
1 Side protection
2 Upper protection
3 Side protection
4 Protection anchorage bracket
5 Self-threading screw 4.2x10 mm
To Next Page
Loading...