LIST OF QUICK COMMANDS
Display contrast control
From the main screen, operate on keys P5 and P6 to increase and decrease respectively.
Back-lighting level control
While holding key P3 down, simultaneously operate on keys P5 and P6 to increase and decrease respectively.
Keyboard lock (children's safety)
Activation and deactivation: Press keys P5 and P6 simultaneously and then key P1.
Perform a cleaning cycle (if working)
While holding key P3 down, press key P1 (CHRONO) briey.
PRELIMINARY OPERATIONS
Before commissioning it is necessary to:
Check that all safety conditions envisioned are veried.
Make the electric connection after having checked that the power supply voltage is that prescribed of 230V~ 50Hz.
Remove the bag containing the instructions, radio control and rod for opening the door from the tank.
Check that there is sucient fuel in the tank for the envisioned operating period.
Open the door and check that the re pot is positioned correctly and rests well on the base and that the door of the
combustion chamber closes correctly.
Check that the hand-held radio control is congured with the appliance (see "Conguration with the appliance" chapter).
Check that the hand-held radio control has a sucient battery level.
Before successive rings, proceed as follows when necessary:
Clean the ceramic glass in the door.
Remove any residues from the re pot.
Clean the combustion chamber.
Empty the ash drawer
Eliminate any residual pellets from the tank that were not used for a long time or accumulations of pellet dust as they may
have lost their initial characteristics for good combustion. This operation must be carried out using a suitable suction device.
SWITCHING THE APPLIANCE ON
NOTE
In the case of commissioning, the auger for feeding the fuel is empty, therefore a suitable amount of time is necessary for it
to ll and to feed the re pot; to do this, use the [PRELOADING] function on the user menu.
To switch the appliance on in [MANUAL] mode, press the
button for three seconds. In [MANUAL] mode, with the
appliance on, the green LED positioned at the side of the
button on the appliance command panel also switches on.
Once red, there are 6 operating status present:
[CLEAN]: the smoke extractor goes to maximum speed to clean the re pot from any residues of the previous combustion
[WARM]: the ring heater begins to heat up. The extractor is active.
[LOAD]: the auger feeds the burner with a sucient amount of fuel for the start of combustion. The smoke extractor is
active.
[WAIT]: combustion is triggered in the re pot.
[IGNITION]: the auger feeds the re pot again with a sucient amount of pellets for appliance heating.
[FIRE ON]: the appliance checks the eective and correct start of combustion, controlling ame regularity.
On conclusion of the ring phase, instead of the operating status, the display shows a rectangular bar representing the power
level of current operation. The air fan activates when the smoke temperature has reached the minimum threshold set in the
relative parameter.
To Next Page
Loading...