ALARMS
The following alarms are envisioned, whose activation takes place with a delay of 60" after the corresponding event has occurred.
On expiry of this time without the event having returned, the stove/insert passes to the alarm status with immediate shutdown
of the stove/insert and activation of the smoke fan and the exchanger fan at maximum speed. The devices are switched-o
successively when the temperature of the smoke goes to a value below 60°C.
Every alarm status, excluding [No pellet] is recorded in the alarms log.
NO START
In the ring status, the smoke temperature has not reached the
minimum threshold envisioned in the maximum pre-established time.
FAIL
In the stabilizing status, the smoke temperature has not increased
with a rhythm of 3°C/minute or has dropped below the minimum threshold.
H. SMOKE
In any status, the smoke temperature has reached and exceeded
the maximum threshold of 280°C.
NO FLAME
During the work status, the temperature of the smoke has dropped below the
minimum threshold.
DEPR. A.
The pressure switch has indicated an anomalous pressure/negative pressure.
SAFETY A.
The reset thermostat has detected a temperature higher than the threshold
at which it has been set.
A. S. PELLET
The internal room probe has been disconnected, it is broken (it
has short circuited or is interrupted).
SMOKE P.
The smoke thermocouple has been disconnected, it is broken (it
has short circuited or is interrupted).
S. FAN
The smoke fan is blocked or turns at a speed lower than 300 g/m.
RECOVERY
Press the key briey to silence the alarm and then press the key for a long time to stop the stove/insert.
ATTENTION
If the stove/insert does not stop, contact the after-sales centre.
NOTE
Do not disconnect the mains electricity until the ame has disappeared completely
Once the switch-o phase has nished, check the cleanliness of the burner and the underlying part.
It is necessary always to remove the fuel present in the burner; also check the level of pellets in the tank is not too low and reload
before re-starting the appliance.
To Next Page
Loading...