ASSEMBLY WITH PEDESTAL OPTIONAL
Description of components:
Q9 DUCTED
Height-adjustable pedestal
Lateral loading hopper
Adjustable hopper support
ASSEMBLY PROCEDURE WITH PEDESTAL
Position the base in the desired point and adjust to the desired height through the feet (the bolts are positioned in the four
external sides of the pedestal at the bottom).
Envision an air vent in the rear of the pedestal in a way that the plug is accessible once installation has been carried out.
Fix the pedestal to the oor using strong steel plugs with diameter of 8 mm.
Take the sliding base and x it to the frame using the bolts.
Connect the smoke exhaust and air vent as reported in the previous paragraph.
Take the insert, tilt it so that the wheels insert themselves on the relevant tracks, make it slide until the coupling of the smoke
auger is completely inserted inside the smoke conveyor box.
PARTS LIST
ELEMENT QUANTITY DESCRIPTION
1 4 Lateral support bracket
2 4 Front/rear support bracket
3 4 Lateral support bracket
4 4 External support bracket
5 4 Floor rest bracket
6 1 Pellet chute anchorage bracket
8 2 Pellet chute adjustment bracket
9 1 Pellet chute
11 1 Pellet chute lateral bracket
13 1 Pellet chute tilted lateral bracket
16 28 Fixing screw
17 28 Nut
18 12 Self-threading screw
To Next Page
Loading...