67
Falcon User Manual - Remittance Processing - OPEX Corporation
IDAssist
The ID Assist tracking system provides an additional method for identifying
and/or taking action on items to be scanned. IDAssist must first be enabled in
the job in order to use this feature. Note that ID Assist will NOT work in Stack
Feed mode.
ID Assist uses three through-beam sensors: ID Assist #1 and ID Assist Verify
are used together to initially enable the ID Assist feature. ID Assist #2 is used
for tracking of items that have been dropped.
Using IDAssist
To trigger IDAssist, swipe the item left to right in front of the ID Assist verify and
ID Assist #1 sensors (see Figure 18) and release. The ID Assist verify sensor
puts the IDAssist feature in an “alert” state waiting to see if the item will be
moved to the right, blocking ID Assist #1. If the item is not swiped left to right,
IDAssist will not be engaged.
Figure 18: IDAssist sensors
When a job is run that uses ID Assist, the IDAssist indicator LED will be solidly
lit. When ID Assist is triggered, the indicator light will blink, indicating that ID
Assist was activated. Once the item is processed, IDAssist will be disabled.
ID Assist verify
ID Assist #2
ID Assist #1
ID Assist indicator LED
To Next Page
Loading...
