Opex Falcon - IDAssist Functions

68
Falcon User Manual - Remittance Processing - OPEX Corporation
If you swipe left to right and do not release the item, or if you grab the item
from the conveyor after releasing it, the sensors will time out and the ID
Assist feature will be disabled.
IDAssist functions
IDAssist (and the optional Multi-slot IDAssist) can be used for the following
functions:
Color The color select trigger identifies items that are to be scanned in color
without having to touch the screen. This is very useful in a color select job,
when you need to tell the system which items to scan in color and which items
to scan normally.
Dropout Similar to color select, this allows for you to trigger a specified color
dropout for an item (red, green or blue).
Transaction boundary Use the transaction boundary trigger instead of the
Transaction button on the run screen. The transaction boundary trigger will
start a new transaction with the item that triggers the sensor.
Automatic rotation of document Tell the system to rotate the resulting image
automatically.
Page type determination requirement Use the IDAssist function to identify a
page type. This function is very useful if you have two page types that are
identical in every way or if there are multiple sets of identical page types. In
these cases, the page types can be set up so that the only way one of the page
types will be identified will be if you trigger the IDAssist function. For example,
in a job with two identical items, a check and a money order page type, the
check and money order can have the same exact attributes with the only
distinction being that money orders must have been triggered by IDAssist. That
way, the system will recognize the checks you scan normally as belonging to
the check page type.
Page sub-type selection The page sub-type selection function is useful in jobs
that have a page type with many page sub-types. Use the trigger to bring up
the page sub-type selection screen so you can choose from among the
available sub-types.
Note: When using the “Page Sub-Type Selection” IDAssist function, you must
select the sub-type before the item enters the scanner. If a page sub-type