SETUP MENU OPTIONS
68
Audio Processing Setup
The Audio Processing section of the Setup Menu allows you to configure how the player will process audio
signals before sending them to the output.
In this section, all of the settings only affect the analogue audio outputs,
except for Dynamic Range Control (DRC) and A/V Sync, which could also affect HDMI, Coaxial and Optical audio.
Speaker Configuration
In the Speaker Configuration menu you can configure speaker settings such as down-mix mode,
number of speakers, their distance, size and trim level. The Speaker Configuration menu shows an
illustration of speaker placement to assist you in properly configuring your speakers.
Upon entering this menu, the cursor is positioned on the front left speaker. You may use the
LEFT/RIGHT ARROW buttons to move the cursor. The RIGHT ARROW button moves the cursor
clockwise, and the LEFT ARROW button moves the cursor counterclockwise. When the cursor is over
the Down Mix, Test Tone or Exit options, you can also use the UP/DOWN ARROW buttons to highlight
these options.
NOTE
Speaker Configuration applies to the multi-channel analogue audio outputs only. All digital
(bitstream and LPCM) outputs are unaffected by these settings.
ᶅᶰᶸᶯᵡᶎᶪᶹ
ᶕᶦᶴᶵᵡᶕᶰᶯᶦ
ᶆᶹᶪᶵ
/
To Next Page
Loading...
