Oppo BDP-103D - Other Audio Processing Settings

SETUP MENU OPTIONS
72
Other Audio Processing Settings
In addition to Speaker Configuration, Crossover Frequency and Dynamic Range Control are audio
processing settings that can be configured:
1. Crossover: Allows you to set the Bass Management kick-in frequency for all speakers. When the
speaker size is set to Small in Speaker Configuration (see page 70), bass information below this
frequency is not passed to the speakers to reduce possible distortion, and if the subwoofer is
available, bass information will be redirected to the subwoofer. When all speaker sizes
are set to
Large, there is no Bass Management.
x
40Hz / 50Hz / 60Hz / 70Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 130Hz / 140Hz / 150Hz
/160Hz / 200Hz / 250Hz
– These are the available crossover frequencies. You can press the
UP/DOWN ARROW buttons and the ENTER buttons to select it. This option applies to all
speakers (centre, front, surround, and surround back speakers). By default the crossover
frequency is 80Hz.
2. Dynamic Range Control: Allows you to set the Dynamic Range Compression (DRC). DRC can
smooth out the sonic peaks and valle
ys common with wide-range digital audio. Enabling DRC may
make low level audio more audible during low-level listening. Turning off DRC restores the sonic
energy present in the original recording.
x Auto – Plays at the dynamic range specified by the disc. This option applies to certain Blu-
ray Discs only, which have DRC instructions encoded in the Dolby TrueHD audio tracks.
x On – Turn on DRC for all Dolby and DTS audio formats. This option applies to all DVD and
Blu-ray Discs.
x Off –TurnoffDRC.
NOTE
Dynamic Range Compression is applied to the analogue audio output and digital audio outputs
(HDMI,Coaxial and Optical) when the audio format is set to PCM.
3. DTS Neo:6 Mode: Allows you to enable DTS Neo:6 audio processing and select the listening mode.
DTS Neo:6 is a digital signal processing that can expand the original stereo source to 7.0 (L, R, C, L
S
,
R
S
, L
R
, R
R
) or 7.1 (with Bass Management) surround.
x Music – Enables DTS Neo:6 audio processing for stereo music sources.
x Cinema – Enables DTS Neo:6 audio processing for digital TV box or stereo movie sources.
x Off (default) – Turns off the DTS Neo:6 to keep the original audio quality.
4. Output
Volume: Allows you to enable or disable the analogue volume controls (also known as Variable
Audio). The available options are:
x Variable – Enables the analogue volume control. Use the VOL+/- buttons on the remote to
increase/decrease the analogue audio output level (the maximum is 100).
x Fixed – Disables the analogue volume control. The VOL+/- buttons on the remote will no
longer affect the analogue audio output, and the volume level is fixed to 100.