Intended use
- 4 -
optek-Manual--1004-1022-02--156-US-2017-12-11
www.optek.com
3 Intended use
The converter is exclusively to be used as a converter for optek-sensor as-
semblies according to the technical data.
In connection with the inline sensors for turbidity, concentration and color, the
converter is used for displaying and processing of measuring results.
The converter is only applicable for sensors listed in the chapter "Technical da-
ta".
The converter is to be installed in a control cabinet, which provides an external
release device so that the converter can be switched voltage-free. Observe
chapter "Technical data".
The use in explosion proof areas is prohibited.
Unauthorized constructional changes, additional fittings or rebuildings as well as
changes to and interference with the converter program are prohibited.
The manufacturer is not liable for damage resulting from use contrary to inten-
ded use.
Following this instruction manual is part of the intended use.
The content of all serial number plates on optek products is model specific and
refers to the time of delivery.
To Next Page
Loading...
