20
Operation
3
Read this chapter to learn how to use and set up the receiver, depending on
your needs.
3.1 Basic Features
To turn your receiver ON or to Standby, use the button on the remote con-
trol. Choose the desired channel with the / buttons. Alternatively, you can
input the channel number with the numeric buttons on the remote control.
Press OK in viewing mode to display the TV Channel List. The volume can be
adjusted with the / buttons.
3.2 Changing channels
Your receiver is equipped with several ways to change the channels.
1. Directly by selecting the channel number buttons 0-9.
2. Through the channel list and OK button.
3. Using the P +, P- or / .
4. Through the EPG.
5. Through the FAV button – lists of favorite channels.
6. Through the button, to switch to the previously viewed channel.
Direct access through the 0-9 buttons
To gain direct access to a certain channel, simply input its number with the
0–9 keys on the remote control. Channel numbers can be up to four digits
long. Entering a number with less than four digits is possible. Just wait a few
seconds and your receiver will switch to the selected channel or press OK im-
mediately after selecting the channel number.
Channel List
Press OK in viewing mode to display a list of channels. Use /
in the channel list to highlight the desired channel and press OK again to
switch to it. Press / or P +, P- to go to the next or previous page by ten
channels. Press OK again to exit the Channel List.
To Next Page
Loading...
