Opticum XS65 - 2.2 First start

9
Installation
2.2 Starting up for the rst time
Turn the TV on and using its functions set the input to the receiver. Turn on
the receiver by pressing the POWER button . The installation guide OSD (On
Screen Display - items displayed on the screen by the receiver) will appear on
the screen. In the subsequent stages of the guide, you can set the basic pa-
rameters of the receiver. At any time you can return to the previous options
using the EXIT button and then you can change your selection. All the set-
ting can be changed in the main menu again.
2.2.1 Language Selection
When you start the guide, the receiver asks you rst to select the language.
Press / to select the desired language and press OK.
2.2.2 Selecting the screen format
Choose the right aspect ratio for your screen (Auto, 4: 3 Pan Scan, 4: 3 Letter
Box) or 16: 9 Widescreen) and press the OK button.
2.2.3 End of the Guide
After a suitable USB is connected, press OK. The receiver will show a message
that it is ready to work. You can go watch, go back to connection of the an-
tenna or settings in order to ne-tune and search for channels. The receiver
will also test the signal. If the tuner is not congured properly, the signal will
not be received correctly and you cannot see all the available channels.
2.3 List of satellites
Press / to select the item you want to edit. Using the red button you can
change the name of the satellite, and also set the length and direction of E -
East and W - West.