OPTIKON PULSAR 2 - Table of Contents

TABLE OF CONTENTS
1. DISCLAIMER .................................................... 1-1
2. TECHNICAL SPECIFICATIONS ................................ 2-1
2.1 DIATHERMY POWER CHARACTERISTICS.................................. 2-5
3. WARNINGS ...................................................... 3-1
4. GENERAL INFORMATION ..................................... 4-1
4.1 EQUIPMENT LAYOUT ....................................................... 4-1
4.1.1 FRONT VIEW (FIG.1) ................................................................... 4-1
4.1.2 LEFT SIDE VIEW (FIG. 2) ............................................................... 4-2
4.1.3 REAR PANEL (FIG. 3) ................................................................... 4-3
4.1.4 INTERNAL VIEW (FIG.4) ................................................................ 4-5
4.1.5 SIDE PLATE .............................................................................. 4-7
4.1.6 UNDER THE MONITOR .................................................................. 4-9
5. PRINCIPLES OF OPERATION ................................. 5-1
5.1 INTRODUCTION ............................................................. 5-1
5.2 CONTROL BOARD 393200 .................................................. 5-6
5.3 GRAPHIC USER INTERFACE ................................................ 5-7
5.4 U/S DRIVER 347150 ....................................................... 5-14
5.4.1 SHEET 1/2 .............................................................................. 5-14
5.4.2 DIATHERMY DRIVER SECTION (SHEET 2/2) ........................................ 5-17
5.5 SENSORS BOARD 393120 .................................................. 5-22
5.6 VACUUM SIGNAL FILTER 369130 ........................................ 5-25
5.7 THE PULSAR
2
POWER BOARD 391110 ................................... 5-27
6. CHECKS AND CALIBRATIONS ................................ 6-1
6.1 POWER SUPPLY BOARD 391110 ........................................... 6-1
6.2 CONTROL BOARD 393200 .................................................. 6-1
6.3 U/S DRIVER 347150 ........................................................ 6-1
6.4 THE SYSTEM CALIBRATION SOFTWARE .................................. 6-2
6.4.1 CALIBRATION SOFTWARE INTERFACE DESCRIPTION ............................... 6-4
6.4.2 EXTERNAL PRESSURE SENSOR AND MAIN PRESS.REGULATOR CALIBRATION ... 6-5
6.4.3 SECONDARY PRESSURE REGULATOR CALIBRATION ................................ 6-6
6.4.4 PROPORTIONAL VALVE CALIBRATION ............................................... 6-6
6.4.5 VACUUM SENSOR CALIBRATION ...................................................... 6-7
6.4.6 TANK FULL ALARM CALIBRATION ..................................................... 6-7
6.4.7 PERISTALTIC PUMP FLOW CALIBRATION ............................................ 6-8
6.4.8 BUILDING THE LOOK UP TABLE ....................................................... 6-8
6.4.9 SYSTEM TESTS AND CALIBRATIONS .................................................. 6-8
6.5 TOUCH SCREEN CALIBRATION ........................................... 6-11
6.6 SETTING DATE AND TIME ................................................. 6-11
7. TROUBLESHOOTING .......................................... 7-1
7.1 WARNING AND ERROR MESSAGES ........................................ 7-1
7.2 MAINS SUPPLY RELATED ERRORS ......................................... 7-5
8. AVAILABLE SPARE PARTS .................................... 8-1