Version 1.2.8 - 2020-08-03 49Translation of original operating manual
MT50 GB
MT50_GB_5.fm
Start of work,
after every
maintenance or
repair work
Spindle gear
Vertical milling
Checking the
oil level
The oil level must at least attain the centre resp. top mark-
ing of the oil sight glass.
Img.6-3: Oil sight glass gear vertical milling
Feed gear
The oil level must at least attain the centre resp. top mark-
ing of the oil sight glass.
Img.6-4: Oil sight glass gear feed
Interval Where? What? How?
To Next Page
Loading...
