Version 1.2.8 - 2020-08-0350 Translation of original operating manual
MT50
GB
MT50_GB_5.fm
First after 3
months then
every
6 months
Spindle gear
Vertical milling
Oil change
For oil change use an appropriate collecting tray of suffi-
cient capacity.
Have the milling spindle run for a few minutes the oil will
heat up and easily penetrate from the opening.
Unscrew the screw from the drain hole.
Img.6-5: Drain hole vertical gear
Unscrew the screw from the filler hole.
Img.6-6: Filler hole vertical gear
Close the drain hole if no more oil drains.
Fill up to the middle of the reference mark of the oil sight
glass into the filler hole using a suitable container.
Interval Where? What? How?
To Next Page
Loading...
