Power on the System for the First Time
4.
Secure the cables to the CMA by closing the covers and tightening the straps.
5.
Verify the operation of the slide rails and CMA.
See “Verify Operation of Slide Rails and CMA” on page 47.
Related Information
■
“Attach the CMA to the Server” on page 41
■
“Verify Operation of Slide Rails and CMA” on page 47
■
“Rear Panel Components” on page 13
Power on the System for the First Time
1.
At the terminal device, log in to the SP.
login: root
Password: changeme
. . .
->
After a brief delay, the Oracle ILOM prompt is displayed (->).
Note - The server is provided with a default Administrator account (root) and a default
password (changeme) to enable first-time login and access to Oracle ILOM. To build a secure
environment, you must change the default password of the default Administrator account as
soon as possible after your initial login to Oracle ILOM. If you find this default Administrator
account has already been changed, contact your system administrator to obtain an Oracle ILOM
user account with Administrator privileges.
For more information about the administration tasks such as changing passwords, adding
accounts, and setting account privileges, refer to the Oracle ILOM documentation.
Note - By default, the SP is configured to use DHCP to obtain an IP address. If you plan
to assign a static IP address to the SP, see “Assign a Static IP Address to the NET MGT
Port” on page 68 for more instructions.
2.
Power on the server using one of the following methods.
■ Press the System Power button.
■ At the Oracle ILOM prompt, type:
Powering On the Server for the First Time 61
To Next Page
Loading...
Need help?
General