Oracle SPARC T8-1 - Attach Slide Rail Assemblies to the Rack

Attach Slide Rail Assemblies to the Rack
the front of the chassis until the mounting bracket clip locks into place with an
audible click.
4.
Verify that the rear locating pin has engaged the mounting bracket clip.
5.
Repeat Step 2 through Step 4 to install the remaining mounting bracket on the
other side of the server.
6.
Attach slide rail assemblies to the rack.
See “Attach Slide Rail Assemblies to the Rack” on page 31.
Related Information
■
“Attach Slide Rail Assemblies to the Rack” on page 31
Attach Slide Rail Assemblies to the Rack
Use the rackmount installation card to identify the correct mounting holes for the slide rails.
Note - Load the rack from bottom to top.
1.
Unpack the mounting brackets and installation card from the rackmount kit.
See “Install the Rackmount Hardware” on page 29.
2.
Ensure that there is enough vertical space in the cabinet to install the server.
See “Rack Compatibility” on page 26.
3.
Place the rackmount installation card against the front rails.
Installing the Server 31