Assign a Static IP Address to the NET MGT Port
Parameter Description
IPv6? Specify whether or not to use IPv6. If you are not sure, select No to configure the Ethernet interface
for IPv4.
Security Policy Select either standard UNIX security (No) or Kerberos Security (Yes). If you are not sure, select No.
Confirm Review the onscreen information and change it if needed. Otherwise, continue.
Name Service Select the name service according to your network environment.
If you select a name service other than None, you will be prompted for additional name service
configuration information.
NFSv4 Domain Name Select the type of domain name configuration according to your environment. If you are not sure,
select Use the NFSv4 domain derived by the system.
Time Zone (Continent) Select your continent.
Time Zone (Country or Region) Select your country or region.
Time Zone Select the time zone.
Date and Time Accept the default date and time, or change the values.
root Password
Type the root password twice. This password is for the superuser account for the Oracle Solaris OS
on this server. This password is not the SP password.
Related Information
■
Oracle Solaris OS documentation
■
“Configure the Preinstalled OS” on page 63
■
“Reach a State to Install a Fresh OS (Oracle ILOM CLI)” on page 63
■
“Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)” on page 65
Assign a Static IP Address to the NET MGT Port
If you plan to connect to the SP through its NET MGT port, the SP must have a valid IP
address.
By default, the server is configured to obtain an IP address from DHCP services in your
network. If the network your server is connected to does not support DHCP for IP addressing,
perform this procedure.
Note - To configure the server to support DHCP, refer to the Oracle ILOM documentation.
1.
Connect to the Oracle ILOM on the SP using the SER MGT port.
If you are not already connected through the SER MGT port, perform steps as needed in
“Connect Cables” on page 51.
68 SPARC T8-1 Server Installation Guide • June 2019