Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)
boot disk1:h - boot from disk1 partition h
boot tape - boot default file from tape
boot disk myunix -as - boot myunix from disk with flags "-as"
dload <filename> ( addr -- ) debug load of file over network at address
Examples:
4000 dload /export/root/foo/test
?go - if executable program, execute it
or if Forth program, compile it
6.
During the installation, supply the configuration parameters as directed.
See “Oracle Solaris OS Configuration Parameters” on page 67.
Related Information
■
“Configure the Preinstalled OS” on page 63
■
“Reach a State to Install a Fresh OS (Oracle ILOM CLI)” on page 63
■
“Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)” on page 65
■
“Assign a Static IP Address to the NET MGT Port” on page 68
Reach a State to Install a Fresh OS (Oracle ILOM
Web Interface)
If you do not plan to use the preinstalled OS, use this procedure to prevent the server from
booting from the preinstalled OS.
1.
Prepare the appropriate boot media according to your installation method.
There are many methods by which you can install the OS. For example, you can boot and install
the OS from external media or from another server on the network.
For more information about the methods, refer to Installing Oracle Solaris 11 Systems,
comparing installation options at:
http://www.oracle.com/goto/solaris11/docs
2.
If you have not done so, perform these tasks to access the Oracle ILOM web
interface on the server.
a.
In a browser on the same network as the system, type the IP address.
b.
Log in to Oracle ILOM by typing your user name and password.
Powering On the Server for the First Time 65
To Next Page
Loading...
Need help?
General