Installing the OS
-> start /System
Are you sure you want to start /System (y/n)? y
The server initialization might take several minutes to complete.
3.
(Optional) Redirect the host output to display on the serial terminal device.
-> start /HOST/console
Are you sure you want to start /SP/console (y/n)? y
Serial console started. To stop, type #.
. . .
4.
(Optional) Execute other Oracle ILOM commands while the server initializes.
a.
To display the Oracle ILOM prompt, press the #. (Hash+Dot) keys.
b.
To see information about available Oracle ILOM commands, type: help
To see information about a specific command, type help command-name
c.
To return to displaying host output from the server initialization, type:
-> start /HOST/console
5.
Continue with the installation by installing the OS.
See “Installing the OS” on page 62.
Related Information
■
“Connect Cables” on page 51
■
“Configure the Preinstalled OS” on page 63
■
“Reach a State to Install a Fresh OS (Oracle ILOM CLI)” on page 63
■
“Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)” on page 65
Installing the OS
Use these topics to either configure the preinstalled OS or use an alternative OS.
■
“Configure the Preinstalled OS” on page 63
■
“Reach a State to Install a Fresh OS (Oracle ILOM CLI)” on page 63
■
“Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)” on page 65
■
“Oracle Solaris OS Configuration Parameters” on page 67
62 SPARC T8-1 Server Installation Guide • June 2019
To Next Page
Loading...
