Oracle X10 - Preparing the Server for Component Replacement; Safety Precautions

Callout Description
15 HHHL PCIe cards – only slots 1 and 5 are populated in Private Cloud
Appliance
16 Two power supplies (PS0, PS1)
Preparing the Server for Component Replacement
This section describes safety considerations and provides prerequisite procedures and
information about replacing components in the server.
Before you can remove and install components that are inside the server, you must perform
the procedures in some or all of the following sections. For more information, see the
component replacement procedures in this guide.
Safety Precautions
For your protection, observe the following safety precautions when setting up your equipment:
• Follow all standard cautions, warnings, and instructions marked on the equipment and
described in the "Oracle Server Safety and Compliance Guide" and "Important Safety
Information for Oracle's Hardware Systems".
• Ensure that the voltage and frequency of your power source match the voltage and
frequency that appear on the equipment electrical rating label.
• Follow the electrostatic discharge safety practices.
• Disconnect both power supply cords (if necessary) before servicing components.
Note:
Power cords must be disconnected when servicing components that require cold
service.
Safety Symbols
The following symbols might appear in this document. Note their meanings.
Caution:
Risk of personal injury or equipment damage. To avoid personal injury or
equipment damage, follow the instructions.
Caution:
Hot surface. Avoid contact. Surfaces are hot and might cause personal injury if
touched.
Chapter 4
Preparing the Server for Component Replacement
4-3