How to Install the Mounting Brackets and Slide Rail Assemblies for a ZS3-2
8.
From the front of the rack, set the proper width of the rails with the width spacer
alignment tool (1).
9.
Tighten the screws on the brackets. (30 lb. torque)
10.
Remove the spacer and confirm that the rails are attached tightly to the rack.
11.
Stabilize the rack, using all anti-tilt mechanisms, to prevent it from tipping during
installation. See your rack documentation for detailed instructions.
86 Oracle ZFS Storage Appliance Installation Guide • February 2016
To Next Page
Loading...
