34 Symbion™ Programmer Guide © Orbotech 2005
Draft - Confidential
• X
and Y Offsets will offset the CAD zero by the values specified
• Angle Offset, should be set to ensure the correct orientation of
components
• Mirroring, Flipping, Rotation of the entire data is achieved by clicking the
orientation marker
o Clicking the arrow head of an axis will flip that axis
o Clicking the intersection of the axes will exchange them
o Clicking in a corner of the board graphic will move the zero to that
point
When importing Multiboard data the options are repeated for the Multiboard
information.
Once complete proceed to the next step
To Next Page
Loading...