© Orbotech 2005 Symbion™ Programmer Guide 65
Draft - Confidential
Setup for Solder Inspection
Overview
The Property Editor provides a tab for Solder inspections. In most cases
setup of the inspections is as simple as activating those required.
Tools are provided for more detailed setup of all Solder inspections.
Not all inspections described will be possible for all Inspection
Types
Possible Solder inspections are;
• Solder Volume, reports an error when the solder joint is detected as
having insufficient or excess solder volume.
Inspection is on or off, the performance of the inspection may be tuned
using the TBA Setup Tool.
•
Solder Open, reports an error when the solder joint is detected as
having open solder joints.
Inspection is on or off, the performance of the inspection may be tuned
using the TBA Setup Tool.
• Short Circuit, reports an error when the terminal is detected as being
shorted with its neighbor.
Inspection is on or off, the performance of the inspection may be tuned
using the TBA Setup Tool.
To Next Page
Loading...