© Orbotech 2005 Symbion™ Programmer Guide 91
Draft - Confidential
First Inspection
Inspection Controls
Inspection is controlled by buttons on the Toolbar, available inspection
functions are;
Acquire Selected Component drives to the location of the
selected component and makes a picture
Inspect Selected Component inspects the currently selected
component, an image must have been previously acquired
Acquire and Inspect Selected Component drives to the
location of the selected component and makes a picture, the
inspection is then carried out
Inspect Current Window inspects all the components
contained within the same window as the selected component,
using the Inspection Manager
Inspect Current Selection drives to the location of the selected
component and makes a picture, using the Inspection Manager
Inspect Active Tagset inspects all the components contained
in the current tagset, using the Inspection Manager
Inspect Recipe inspects the entire recipe, using the current
Inspection Set
Click the button to carry out the inspection.
To Next Page