Oregon Scientific SE332 - Other Operations and Settings; Activate Backlight; Beep Tone on; off; Replace Battery

EN
9
To delete memory:
1. Press MODE/- repeatedly to select “MEM”.
2. Press +/ST/SP repeatedly until “DELETE” will be
displayed.
3. Press MODE/- to conrm.
DONE indicates the record has been cleared.
MODE/-
MODE/-
+/ST/SP
When starting an exercise and memory is full, “FULL” will be
displayed, followed by “DELETE”.
• Press MODE/- to delete all records
OR
• Press +/ST/SP to ignore and start an exercise without
recording data for it.
OTHER OPERATIONS AND SETTINGS
ACTIVATE BACKLIGHT
Press EL/LOCK. (Press any key to extend backlight for
another 5 seconds).
NOTE The backlight function will not operate if “ ” is
displayed.
BEEP TONE ON / OFF
When time is displayed, press +/ST/SP to activate /
deactivate beep tone.
indicates beep tone is deactivated.
REPLACE BATTERY
If the battery power of your watch is low, the watch will
display: .
To replace watch battery:
1. Use a coin to open the battery compartment lid by
turning it anticlockwise.
2. Remove the old battery and insert a new CR2032, 3V
lithium battery.
3. Secure the lid by turning the coin clockwise.
IMPORTANT Remember to set the proles after every
battery replacement or reset.