OSRAM BT Control | General information
10
2)
3)
1)
1)
Do not place any mains voltage or LED supply wires within or close to this area
2) Recommended minimal distance to metal parts
3) Placement of integrated radio transmitter antenna
Guidelines for product placement to optimize the stability and effective range of the BT connection
1. Preferable installation on systems free from metal obstructions or material that heavily weakens the radio frequency
signal (e.g. fiber-reinforced plastic).
2. Do not place inside metal boxes!
3. Keep a distance between the antenna area and the mounting surface (see best practice below).
4. Do not wire cables (mains voltage, LED supply wires) near the antenna area and, if possible, out of the device border.
5. Consider an installation height above the furniture and human obstacles (e.g. >1.6 m above the floor).
DALI ECO BT, DALI ECO BT RTC
DALI ACU BT
2.4.3 Radio optimization
The wireless Bluetooth Low Energy (BLE) interface is based on the Bluetooth 4.0 protocol.
Connectivity range: ≤ 15 m
Mounting instructions
Mounting instructions
1)
2)
3)
To Next Page
Loading...
Need help?
General