Osram BT Series - Page 56

OSRAM BT Control | Applications and settings
56
Activate the Swarm feature
Nine (9) BT Control devices need to
be connected – one by one!
1. Open the main menu.
2. Open “Settings”.
3. Open “Profile”.
Please enter the following:
4. Name = ExpertUser
Company = OSRAM
5. Click on “Save”.
Go back to the main menu.
The profile change can now be
identified by:
6. Name = ExpertUser
Additional function = Diagnostic
5.2.7.6 Activation of Swarm feature via Expert mode 5.2.7.7 Creation of different Swarm zone/s
Depending on the room setup, the independent desk lumi-
naires can be integrated into different light zones. A wireless
information transfer between zones is guaranteed due to the
activated Swarm feature in each BT Control device. Neverthe-
less, each of the zones will react independently and switch on
their lights when presence is detected. Additionally, lights in
other zone/s can react as well, according to the configuration
for each of the linked zones.
Create the Swarm zone/s
1. Open “Swarm”.
2. Enable the “Swarm function” for
this BT Control.
3. Now choose which zone (1 to 5)
this BT Control belongs to, as each of
the nine BT Control devices needs to
be in different zone/s for standby fea-
ture.
4. Click on “Configure” in “Standby
zone selection”.
5. Define the standby zone/s for this
BT Control.
Important information:
— System boundaries:
— Max. 20 participants in one zone
— Max. 20 different zones
— Max. 50 different rooms
— Max. 50 different areas
— Presence information can only be
exchanged between controllers
with the same area and room
number.
— Configuration of standby zone/s:
The standby zone/s are the zone/s
which go into standby mode while
this BT Control is triggered by
presence detected!
For example: This BT Control is in
zone 4. The standby zone/s triggered
by presence detection of this BT
Control can be freely chosen – e.g.
zone 5 only or zones 3 and 5 or
even all other zones, meaning zones
1, 2, 3 and 5.
Now scroll down in the Swarm menu:
6. Check the “Switch off delay”.
7. Enable “Activate standby level”.
8. Define the “Standby level” and “Standby time” for
this BT Control.
Attention: All BT Control devices linked in
zone/s should
have the same parameters
programmed for an even and timely
light distribution!
2
1
4
3
5
6
1
2
3
4
5
8
7
6