Pace PAI - FIGURE 87 - Position Pre-Filter in Front of Final Filter; FIGURE 88 - Spring End of Latch; FIGURE 89 - Completed Assembly

Form PA102.20-N1
55
Installation & Assembly Manual │ PACESECTION 3 - HANDLING, STORAGE, AND INSTALLATION
Issue Date: 07/03/2018
3
3. Place the pre-lter against the face of the Multi-
Cell SBM DH lter. The pre-lter latches may have
to be re-positioned as shown in Figure 87 on page
55, to allow the proper placement of the pre-
lter.
LD10165
Figure 87 - Position Pre-Filter in Front of Final Filter
4. Grasp the end of the pre-lter latch and spring
it, so that it ts over the edge of the pre-lter as
shown in Figure 88 on page 55.
5. Repeat this step with the remaining latches.
LD10190
Figure 88 - Spring End of Latch
After placing all remaining pre-filter latches around the
pre-filter; the finished assembly should look like the
one shown in Figure 89 on page 55.
LD10167
Figure 89 - Completed Assembly