5
Table of contents
10 Adjusting and testing installed tail lift ....................... 50
10.1 Set tilt switch b13 .................................................................... 50
10.2 Air bleeding the hydraulic cylinders ........................................ 51
10.3 Checking horizontal position on ground ................................. 51
10.4 Performing an oil level check .................................................. 52
10.5 Checking screw connections .................................................. 53
10.6 Attaching warning strips and type plate .................................. 54
10.7 Adjusting the optional pressure switch of
the hydraulic support ..............................................................54
10.8 Performing acceptance test as per test book ......................... 56
11 Index .............................................................................. 57
12 Hydraulic circuit diagrams .......................................... 59
To Next Page
Loading...
Need help?
General
